Skip to main content

Tech View and Board View on the Work Orders Page

Three ways to see your work orders: List, Tech View grouped under each lead technician, and Board View with a column per technician and drag to reassign.

Three ways to see your work orders

  • List, Tech View and Board View sit on the toolbar of the Work Orders page. List is the default and works exactly as it does today.

  • Tech View is the table you know, grouped under each lead technician. Groups can be collapsed, and ShopView remembers which ones.

  • Board View gives each technician a column, with a card for each work order. Each column scrolls on its own.

  • Unassigned always comes first. On Board View it stays in place while you scroll sideways.

  • Each technician shows a count that matches your filters, and every technician appears, even with nothing assigned.

See everyone on the job

Each work order shows the lead technician first, then the technicians on its lines. Tech View has a new optional Assigned Techs column. On a work order's Lines tab, a line with scheduled technicians but no labor technician shows their names instead of Unassigned.

Set the order of work

Drag work orders up and down under a technician. The order is saved for your location, and everyone sees it in both views. To change who a job belongs to, see the article Changing a Work Order's Lead Technician.

Pins

Pin up to 3 technicians so they always show first, right after Unassigned. Pins and the order of technicians are yours alone; the order of work under each technician is shared by everyone at the location.

Your view, your way

  • Column Selection sets what each Board View card shows. The work order number, unit number and status always show on the card.

  • Tech View has its own column chooser, separate from List.

  • Density on Tech View offers Compact, Regular or Comfortable. It changes spacing only.

  • The view you pick follows you across devices and locations.

Who can do what

Everyone gets Tech View and Board View on release, with nothing to switch on; List stays the default. Switching views needs access to Work Orders. Dragging and reassigning needs permission to edit work orders. There is no new permission.

FAQ

Where is Density on Board View? Where is Fields to display?
Board View has no Density control in this release, and its card settings are called Column Selection. Tech View keeps its Density control. A Compact / Detailed card size for Board View comes later; it is not in this release.

I can't see Tech View or Board View.
They need access to Work Orders and a screen 1024px wide or wider. Narrower screens show List. Imported work orders open in List only.

I can't drag a work order.
Dragging and reassigning needs permission to edit work orders. On an Invoiced or Paid work order the lead technician can't change, but the work order can still be reordered within its technician.

The tech story check mark has gone from my lines.
It was removed in this release. Entering, editing and requiring tech stories work as before.

My colleague sees different pinned technicians.
Pins and the order of technicians are per person. The order of work under each technician is shared by everyone at the location.

Did this answer your question?